Hinweis
Für den Zugriff auf diese Seite ist eine Autorisierung erforderlich. Sie können versuchen, sich anzumelden oder das Verzeichnis zu wechseln.
Für den Zugriff auf diese Seite ist eine Autorisierung erforderlich. Sie können versuchen, das Verzeichnis zu wechseln.
Applies To: Windows Server 2008
.jpg)
The server running Routing and Remote Access uses a routing interface to forward unicast IP and multicast IP packets. There are two types of routing interfaces: LAN interfaces and demand-dial interfaces. A LAN interface is a physical interface that typically represents a local area connection that uses local area networking technology such as Ethernet or token ring. A demand-dial interface is a logical interface that represents a point-to-point connection. The point-to-point connection is based on either a physical connection, such as two routers connected over an analog phone line that uses modems, or a logical connection, such as two routers connected over a virtual private network (VPN) connection that uses the Internet.
Event Details
| Product: | Windows Operating System |
| ID: | 20183 |
| Source: | RemoteAccess |
| Version: | 6.0 |
| Symbolic Name: | ROUTERLOG_IF_UNREACHABLE_REASON5 |
| Message: | Interface: %1 is unreachable because it is not allowed to connect at this time. Check the dial-out hours configured for this interface. |
Resolve
Configure dial-out time restriction
To perform this procedure, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.
To configure dial-out hours:
- Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
- In the console tree, click Network Interfaces.
- In the details pane, right-click the demand-dial interface you want to configure, and then click Dial-out Hours.
- In the Dial-out Hours dialog box, select the appropriate day and time boxes to either permit or deny dial-out access, click either Permitted or Denied, and then click OK.
Verify
To verify that the remote access server can accept connections, establish a remote access connection from a client computer.
To create a VPN connection:
- Click Start, and then click Control Panel.
- Click Network and Internet, click Network and Sharing Center, and then click Set up a connection or network.
- Click Connect to a workplace, and then click Next.
- Complete the steps in the Connect to a Workplace wizard.
To connect to a remote access server:
- In Network and Sharing Center, click Manage network connections.
- Double-click the VPN connection, and then click Connect.
- Verify that the connection was established successfully.