Hinweis
Für den Zugriff auf diese Seite ist eine Autorisierung erforderlich. Sie können versuchen, sich anzumelden oder das Verzeichnis zu wechseln.
Für den Zugriff auf diese Seite ist eine Autorisierung erforderlich. Sie können versuchen, das Verzeichnis zu wechseln.
Applies To: Windows Server 2008
The server running Routing and Remote Access uses a routing interface to forward unicast IP and multicast IP packets. There are two types of routing interfaces: LAN interfaces and demand-dial interfaces. A LAN interface is a physical interface that typically represents a local area connection that uses local area networking technology such as Ethernet or token ring. A demand-dial interface is a logical interface that represents a point-to-point connection. The point-to-point connection is based on either a physical connection, such as two routers connected over an analog phone line that uses modems, or a logical connection, such as two routers connected over a virtual private network (VPN) connection that uses the Internet.
Events
| Event ID | Source | Message |
|---|---|---|
RemoteAccess |
Unable to load the interface: %1 from the registry. The following error occurred: %2 | |
RemoteAccess |
Unable to add the interface: %1 with the router manager for the %2 protocol. The following error occurred: %3 | |
RemoteAccess |
Unable to remove the interface: %1 with the router manager for the %2 protocol. The following error occurred: %3 | |
RemoteAccess |
The demand-dial interface: %1 was not loaded. The router was not started in demand-dial mode. | |
RemoteAccess |
The demand-dial interface: %1 was not registered with the router. Demand-dial interfaces are not supported on a Windows NT Workstation. | |
RemoteAccess |
Interface: %1 is unreachable because there are no modems (or other connecting devices) available for use by this interface. | |
RemoteAccess |
Interface: %1 is unreachable because the connection attempt failed. | |
RemoteAccess |
Interface: %1 is unreachable because it has been administratively disabled. | |
RemoteAccess |
Interface: %1 is unreachable because the Routing and Remote Access service is in a paused state. | |
RemoteAccess |
Interface: %1 is unreachable because it is not allowed to connect at this time. Check the dial-out hours configured for this interface. | |
RemoteAccess |
Interface: %1 is unreachable because it is currently not connected to the network. | |
RemoteAccess |
Interface: %1 is unreachable because the network card for this interface has been removed. |